Skip to main content

Connect Enrow to OpenClaw

Add Enrow to OpenClaw with one command, then sign in with your Enrow account.

Written by Thomas Lucy

To use Enrow in OpenClaw, the open-source agent that runs on your computer, add the Enrow server with one command, then sign in to your Enrow account in your browser. You don't need an API key. You need OpenClaw 2026.9 or later.

These steps are also in the Enrow app, with copy buttons: go to Integrations in the left menu, click the MCP tab, then click Connect on the OpenClaw card.

Connect OpenClaw

  1. In a terminal, run this command:

    openclaw mcp add enrow --url https://mcp.enrow.io/mcp --transport streamable-http --auth oauth

  2. Start the sign-in:

    openclaw mcp login enrow

  3. Your browser opens, or the command shows the address to open. Sign in to Enrow if asked, then click Allow.

  4. Check the connection: the enrow line should show oauth authorized.

    openclaw mcp status --verbose

  5. Send this test prompt to OpenClaw in a new conversation: "Use Enrow to check my credit balance." The answer shows your balance. Reading your balance uses no credits.

Note: If you belong to an Enrow team and you are not its owner, you can't sign in from apps on your computer. Connect OpenClaw with your team's API key instead: see Connect any other MCP client.

If something goes wrong

  • The sign-in page says the request has expired. A sign-in request is valid for 10 minutes. Run openclaw mcp login enrow again.

  • Enrow stopped working or asks you to sign in again. The access was disconnected in Enrow, or it expired. Run openclaw mcp login enrow again.

  • Enrow says a paid plan is required or a limit is reached. See Use Enrow in an AI assistant (MCP): overview.

To remove OpenClaw's access, go to Profile > Applications in Enrow and click Disconnect. Removing Enrow from OpenClaw is not enough: the access stays active in Enrow until you disconnect it.

Related articles

Did this answer your question?